Support Center

What can make the connection to the access point fail? (1/5)

Last Updated: May 23, 2014 07:01AM UTC
First retry a few times. Then check if you have DHCP disabled on your access point. If this should be the case, enable it and retry.

If the configuration still fails, try the following: disconnect from the "koubachi_config" network. Perform a hard restart of the configuration modus of the plant sensor. Afterwards connect again to the "koubachi_config" network. Click on "Rescan for Wi-Fi networks".

Contact Us

support@koubachi.com
https://cdn.desk.com/
false
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
false
Invalid characters found
/customer/en/portal/articles/autocomplete